Safelite New Baltimore Mi (2024)

FAQs

How long to keep tape on new windshield safelite? ›

During windshield replacement, the auto glass technicians will sometimes use specialized tape to help secure the windshield. Any tape should be left in place for at least 24 hours, preferably longer. Be sure to remove the tape carefully and completely.

Most auto glass repair specialists recommend waiting a minimum of one hour before you drive your vehicle again, but that timeframe can vary. Standard driveaway times typically range from 30-75 minutes, but some new windshields require up to 24 hours to dry.

Avoid driving in heavy rainS for the first 24 hours after installation. Keep your windows closed while driving in the rain immediately after windshield replacement to prevent water from seeping inside and damaging the interiors and sealant. Windshield wipers are a must only if you are driving in the rain.

Some glass businesses recommend waiting at least 48 hours after the replacement has been completed, but as a general rule of thumb, it is wise to wait 24 hours from when the replacement was done.

When shops say you'll be in and out, that's true, but as a driver, you should understand that your windshield may not hold up in an accident unless the urethane adhesive is fully dry. It takes about 8 hours or overnight for urethane adhesive to dry fully.

The windshield tape ensures that the resin adhesive gets sufficient time to cure. The tape also helps protect the windshield seal against elements while the adhesive and the seal set and dry. When dirt, dust, water, and debris are not kept away, they might ruin the installation.

When a door or hood is slammed, there's a chance that the windshield's seal can be broken. You should also avoid using your windshield wipers as much as possible for the first couple of days. If you must use them, limit the driving time to 2 hours.

The windshield resin requires 15-20 minutes to properly cure. During this period, it is extremely important not to expose the windshield to high temperatures, cold or rain. If the resin doesn't fully cure, issues will arise later. The resin might swell later due to being exposed to excessive temperature.

It is 100% necessary for drivers to recalibrate their ADAS after replacing their windshield.

Urethane. A powerful adhesive used to bond the glass to the frame of the vehicle.

Do windshields leak after replacement? ›

Occasionally, tiny leaks go unnoticed for months and even years after a windshield replacement, so determining a possible cause can be somewhat difficult. Take your vehicle to a reputable auto glass repair company for a thorough diagnosis.

An incorrect windshield replacement results in gaps between the frame and the glass. While driving, you will hear a whooshing sound even with closed windows. During heavy rains, you will also notice water seeping in through the gap. You can easily spot wavy patterns on an incorrectly installed windshield.

Your windshield cannot be repaired in the rain. Your windshield should be completely dry to ensure that the resin can properly adhere to the crack or chip. However, this does not mean all hope is lost if it is raining. Most windshield repair shops have a garage or covered area where they can perform the repair.